橡胶注模成型通常要求：低温料和高温模。同机状况下必须采用隔热方法。保持注模高温同时不能使成型机温度过高。在注模与注机之间安装Frathernit 绝缘板就能满足这一要求。 Rubber injection moulding usually means: Cold liquid and hot mould. Both in one machine need a thermal insulation. Keep the mould hot enough and make sure the machine will not be too hot. Frathernit Insulation boards mounted between moulds and machine can guarantee that.

优势Advantages：

● 缩短生产周期，提高生产率。
● Shorten the production cycles and increase productivity
● 降低能耗。
● Reduce energy consumption
● 成型机温度过高极易造成液胶在机内过早固化。
● Too hot machines means hardening of the rubber in the machine.
● 改善成品质量，连续生产工艺保证了产品质量稳定。
● Improve product quality, constant quality because of constant production process.
● 防止机器过热：无电器故障，液压系统无漏油。
● Protect machine from overheating: No electronic defects, no oil leaking in the hydraulic system.

如果产品更特别，工况更复杂，我公司还提供注模外部隔热，保证生产过程更稳定。
If your product are more special and your problems grow bigger, we also can offer Mould outside insulation to keep your production more constant.

模具外部隔热板
Mould outside insulation

温度降幅图 Graphics of temperature decrease